Susan’s new grab bars

It’s been a year since Susan first starting getting vertigo and although it doesn’t happen as often as it used to, her balance is still poor.  To make it easier for her to get around inside the motor home I decided to install a couple more grab bars.

The problem is that the kind of grab bars you can buy at Home Depot have wide bases, usually 4 inches or so across.  The interior cabinetry and walls of the motor home don’t have 2 x 4 studs to screw things into.  In fact, in order to keep weight down the structural elements are only at the corners and in between is very thin veneer plywood. Two years ago I made grab bars out of 1″ x 3″ oak that got around this problem by being narrow enough to install at the edge of the cabinets over and beside the bed.

This time I started with two pieces of 1″ x 3″ x 24″ oak and used a jig saw to round the outer corners and a bandsaw to cut out the interior space, leaving a handle shape.  I used my router to round the edges and a belt sander in the RV park’s workshop to smooth everything.  I then drilled and countersunk holes for screws using the workshop’s drill press.  I then gave them two coats of polyurethane and stain (sanding lightly in between coats).  Finally I used 4″ brass wood screws (that I had to order on-line because nobody carries brass screws that long locally) to fasten one just inside the doorway to the bedroom and one just inside the hallway.

Grab bar to the left of the doorway in the bedroom.
Grab bar to the left of the doorway in the bedroom.
grab_bar_hallway_2
Grab bar in the hallway (other side of the doorway to the bedroom).

I am pleased to say that they’re very sturdy.  I’ve put my full weight on them and they don’t budge.  Susan has used them several times already and says they are a real help so I think it was worth the time I put into them.

Leave a Reply

Your email address will not be published. Required fields are marked *